Wayne-Dalton Z-WAVE WDTC-20 User Manual
Page 22
Manual operation
To manually operate your Zwave
Enabled Thermostat
:
noTE:
Confirm your thermostat has
stabilized to room temperature prior
to operation.
1. Confirm the Fan is in Auto mode
by sliding the FAN switch to the left.
noTE:
To run the fan continuously
with or without HEAT or COOL,
slide the FAN switch to the right
to the ON position.
2. Press and release the desired
temperature mode, either HEAT
or COOL. The LCD will display
either HEAT or COOL to match your
selection.
noTE:
To turn the thermostat
OFF, press the button that
matches the active mode showing
on the display. For example,
if HEAT is displayed, press the
HEAT button. The display will
then not show either HEAT
or COOL and will display the
current room temperature only.
3. Press and release the desired
operation mode, either NORMAL
or SAVE ENERGY, to activate the
desired pre-set temperature. The
display will show the TARGET
TEMPERATURE.
noTE:
The display will return
to the ROOM TEMP after 5
seconds.
4. (OPTIONAL) If the target
temperature is not suitable, press
either the temperature up button
(+ symbol) or temperature down
button (- symbol) until the desired
target temperature is reached.
22
operation
noTE:
The NORMAL and SAVE ENERGY buttons
allow you to quickly switch between the NORMAL
target temperature and the SAVE ENERGY target
temperature, sometimes referred to as a set-back
temperature.
AUTO
ON
FAN
HEAT
COOL
SAVE
ENERGY
NORMAL
RESET
COOL
1
2
3
4