Wayne-Dalton Z-WAVE WDTC-20 User Manual

Page 18

Installation

Step 8: Control Unit preparation

prepare the Z-Wave

Enabled

Thermostat Control Unit for

Installation:
1

. Install 2 AA batteries as shown in

the diagram to the right. The batteries
are required to maintain your target
temperatures during a power outage.
If battery power is lost, or when
changing batteries, you must reset
your target temperatures.
noTE:

Use Alkaline Batteries only,

do not use rechargeable batteries.
noTE:

Replace the batteries if

the low battery indicator icon is

displayed.
opEraTIon noTE:

If the batteries

die during a power outage, when

AC power is restored the thermostat

will power up in the OFF state.
2. Press and release the RESET
button on the front of the control unit
to initialize your jumper settings. If
jumper settings are changed, you must
press the RESET button.

Low Battery Icon
Located on Thermostat
LCD Display

COOL

HEAT

SAVE

SAVE

ENERGY

NORMAL

RESET

Step 9: Control Unit Installation

Install the Z-Wave

Enabled

Thermostat Control Unit to the

thermostat base mounted to the

wall in Step 3.

1. Install the Thermostat Control
Unit to the thermostat base in the
following manner:
a) Hook the top of the Control Unit
to the thermostat base.
b) Swing the unit down until it
snaps in position.
c) Push firmly on the center of the
Control Unit to ensure the electrical
contacts are mated properly.

noTE:

After handling, the control

unit may require up to one hour to

stabilize to room temperature.

