Wilton FK350-4 - Manual (Page 10)

10
Controls
Control Panel – FK350
The Control Panel (Figure 4) is located on the
front the cabinet stand and consists of the
Power and High/Stop/Low switches, described
below.
Power Switch – The Power switch has two
positions, Off and On.
High/Stop/Low Switch – This switch controls
the blade speed. To operate the saw, the power
switch must set to on, High or Low must be
selected and the Run Trigger depressed.
Figure 4
Trigger Handle – FK350
To operate, the Power switch must be set to on
a Hi or Low speed selection made, and the
trigger handle, depressed.
Figure 5
Control Panel – FK350-SX
Emergency – Emergency Stop: This turns off
the controls, and the machine. When used, it
requires that “Control On” button be pushed.
Vise – Open/Close (Manual mode
Mode selection – Select Semi-auto, or Manual
mode.
Start – In manual mode, this starts the saw
blade. In Semi-auto, this starts the cut-cycle.
Head-UP/ Head-Down – Manual mode only
Feed rate – sets feed rate of cut cycle
Figure 6
High/Stop/Low Switch – Refer to Figure 7;
located on the front of the cabinet stand;
controls the blade speed (Figure 7).
Figure 7