Wilton 3400 User Manual
7 x 12 cut-off band saw, Operating instructions — parts manual, Models
Table of contents
Document Outline
- 3400/3410 7 x 12 Cut-off Band Saw
- Warranty and Service
- Table of Contents
- Specifications
- Warnings
- Safety instructions
- Operating Instructions
- Using the vise
- Locking vise jaw
- Changing the locking jaw location
- Stationary vise jaw
- Changing the stationary vise jaw postion
- Adjusting stationary jaw
- Adjusting angles with the scale on the saw table
- Adjusting stationary jaw for high accuracy angle cutting
- Setting the blade guides
- Controlling the cut:Hydraulic feed control
- Using the stock stop for repeated cuts
- Changing blade speeds
- Blade selection
- Evaluating cutting efficiency
- Blade break-in procedures
- Starting a cut
- Right angle cuts -- single pieces of stock
- Angle cutting
- Maintenance
- Replacing blades
- Adjusting blade tracking
- Blade alignment adjustments
- When to adjust the blade guides
- Replacing blade guide and support components
- Adjusting blade vertical
- Test cutting to verify adjustment accuracy
- Adjusting guide bearings
- Replacing guide bearings
- Adjusting blade back-up bearings
- Replacing the drive wheel
- Installing the vertical sawing table
- Replacing idler wheel or bearing
- Servicing the hydraulic control cylinder
- Machine Set-up
- Troubleshooting
- Ordering Replacement Parts
- Replacement Parts
- Saw Head
- Saw Base
- Hydraulic Cylinder