Weil-McLain GOLD CGs - Manual (Page 9)

V V V V Vertical Direct V ertical Direct V ertical Direct V ertical Direct V ertical Direct Venting — V enting — V enting — V enting — V enting — Venting Supplement enting Supplement enting Supplement enting Supplement enting Supplement
Part Number 550-141-873/0502 9
Figure 6 Parts provided in kit Table 2 Parts provided in kit
1
2
6
3
4
7
8 5
87302
Table 3 Parts below are required for installation and are provided by installer (not included in kit)
Item Description Qty
1 Tee —
galvanized 5" x 5" x 3" 1
2 Vent clamp 5
3 Bottom cap —
galvanized with 4 ½" hole 1
4 Vent support 1
5 Elastomer grippers 11
6 Screws — sheet metal
type A, #10 x 1¼" 11
7 Screws — sheet metal
type A, #10 x ½" 3
8 Elastomer flashing 2
Description Quantity
Rain cap, galvanized, 5" 1
Adjustable flashing, type B, 5" 1
Fire stop for each floor or attic penetration 1
Storm ring, type B, 5" 1
Support, type B, 5" 1
Draft hood connector, type B, 5" 1
Adequate B-Vent with clamp rings for combustion air run (less than 30 feet) --
Adequate 3" vent material for vent run and elbows from one of the following (See Note):
• Heat-Fab, Inc. — Saf-T Vent
®
• ProTech Systems — FasNSeal™
• Flex-L International, Inc. — StaR-34 • Z-Flex
®
, Inc. — Z-Vent II
--
Adequate sealant specified by vent pipe manufacturer’s instructions --
Adequate 3" PVC, galvanized or dryer vent (for combustion air supply piping between tee and boiler) --
Note: Do not mix types of vent material. CSA certification will be void.