Weider WESY17011 - Manual (Page 8)

8
7. Lubricate both axles on the Top Frame (55). Slide
the Right Arm (48) onto the right axle. Note: Be
careful not to confuse the Right Arm with the
Left Arm (47); refer to step 6 to identify the
Right Arm. Be sure that the upper end of the
Right Arm is behind the indicated bracket on
the Top Frame.
Tap two 25mm Retainers (63) and a 25mm
Round Cover Cap (62) onto the right axle. Be
sure that the teeth on the Retainers bend
toward the Cover Cap, as shown in the inset
drawing.
Attach the Left Arm (47) in the same manner.
Press 45mm Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the lower end of each Arm with soapy water.
Slide a Large Foam Pad (45) onto the lower end
of each Arm.
7
Bracket
Lubricate
Axle
45
47
55
48
45
44
63
62
63
55
62
CABLE ASSEMBLY
8
9
23
58
55
16
21
Hook Ball
15
58
8. During steps 9 through 22, refer to the CABLE
DIAGRAM on page 20 of this manual to verify
proper cable routing. Before beginning this sec-
tion, identify the Short Cable (23) and the Long
Cable (58) by comparing the lengths and the
ends of the cables.
IMPORTANT: While assembling the cables, do
not overtighten the bolts and nuts securing
the pulleys; the pulleys must turn freely.
9. Locate the Long Cable (58). Route the Long
Cable around a 90mm Pulley (15).
Using an M10 x 90mm Bolt (16) and an M10
Nylon Locknut (21), attach the 90mm Pulley (15)
to the Top Frame (55) in the indicated location. Be
sure that the end of the Cable with the ball is
on the indicated side of the Pulley and that
the Cable is between the Pulley and the hook
on the Top Frame.