Weider WESY17011 - Manual (Page 12)

12
21. Route the Short Cable (23) up around the
90mm Pulley (15) attached to the upper hole in
the Press Frame (17). Be sure that the Cable is
routed around the Pulley as shown, and that
the Cable Trap (66) is turned to hold the Cable
in place.
Route the Short Cable (23) around the
90mm Pulley (15) attached to the upper hole in
the Front Upright (42). Refer to the inset draw-
ing. Be sure that the Cable is routed around
the Pulley as shown, and that the Cable Trap
(66) is turned to hold the Cable in place.
21
23
42
15
15
66
21
17
23
Inset shows view
from other side
42
66
15
22. Attach the end of the Short Cable (23) to the
Long “U”-Bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (8). Do not completely
tighten the Nylon Locknut; it should be
threaded onto the end of the Cable until two
threads are showing above the Nylon
Locknut, as shown in the inset drawing.
22
57
3
8
23
23
57
3