Weider WESY17011 - Manual (Page 11)

11
17
21
15
12
15 66
9
21
4
Bracket
17
25
17. Using an M10 x 80mm Bolt (25), an M10 Washer
(9), and an M10 Nylon Locknut (21), secure a
90mm Pulley (15) and a Cable Trap (66) to the
upper hole in the Press Frame (17). Make sure
that the Cable Trap and the Pulley are oriented
as shown.
18. Locate the Short Cable (23). Lay the Short
Cable inside the bracket on the Base (4). Attach a
90mm Pulley (15) inside the bracket with an M10
x 45mm Bolt (12) and an M10 Nylon Locknut
(21). Be sure that the ball on the Cable is on
the indicated side of the bracket.
23
Ball
18
19. Attach two 90mm Pulleys (15) and two Cable
Traps (66) to the Front Upright (42) with two M10
x 90mm Bolts (16), two M10 Washers (9), and
two M10 Nylon Locknuts (21). Be sure that all
parts are oriented as shown. Do not tighten
the Nylon Locknuts yet.
20. Route the Short Cable (23) around the 90mm
Pulley (15) attached to the lower hole in the Front
Upright (42). See the inset drawing. Be sure
that the Cable Trap (66) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the M10
Nylon Locknut (21) and the M10 x 90mm Bolt
(16).
20
23
21
42
15
16
23
Inset shows view
from other side
42
66
15
19
21 15
15
16
9
42
66