Weider WESY17011 - Manual (Page 10)

10
14. Locate the Long “U”-Bracket (57) that is pre-
assembled with a 90mm Pulley (15) and a Cable
Trap (not shown). Route the Long Cable (58)
around the Pulley and through the Long “U”-
Bracket. Be sure that the Cable is in the
groove of the Pulley, that the Cable Trap is
turned to hold the Cable in place, and that the
Cable and Pulley move smoothly.
15. Route the Long Cable (58) around a 90mm Pulley
(15). Using an M10 x 45mm Bolt (12) and an M10
Nylon Locknut (21), secure the Pulley to the indi-
cated bracket on the Top Frame (55). Be sure
that the Cable is in the groove of the Pulley
and that the Cable and Pulley move smoothly.
14
58
57
15
15
12
15
58
Bracket
55
21
16. Attach the Long Cable (58) to the Weight
Carriage (19) with an M10 x 20mm Bolt (69) and
an M10 Nylon Locknut (21). Make sure that the
Bolt and the Nylon Locknut are tight.
16
19
21
69
58