Weider WESY17011 - Manual (Page 6)

6
1
56
3
5
51
51
14
1
27
4
1. Before beginning assembly, be sure that you
have read and understand the information in
the box on the previous page.
Press a 50mm Square Outer Cap (51) onto each
end of the Stabilizer (5). Press a 50mm Square
Inner Cap (27) into the end of the Base (4).
Insert two M8 x 67mm Carriage Bolts (14) up
through the Stabilizer (5). Insert two M8 x 63mm
Carriage Bolts (1) up through the Base (4).
Slide the bracket on the end of the Base (4) onto
the M8 x 67mm Carriage Bolts (14) in the
Stabilizer (5). Slide the Rear Upright (56) onto the
Carriage Bolts. Hand tighten an M8 Nylon
Locknut (3) onto each Carriage Bolt. Note: Be
sure the indents around the holes in the
Stabiliser are on the bottom.
FRAME ASSEMBLY
2. Refer to drawing 2a. Press a 25mm Round Inner
Cap (49) into each end of the weight tube on the
Weight Carriage (19). Note: The Square Slider
Bushings (70) should be pre-assembled to the
Weight Carriage and the Weight Stop (67).
Turn the Weight Stop (67) so that the hole in the
Weight Stop is oriented in the same direction as
the hole in the bottom of the Rear Upright (56).
Make sure that the Square Slider Bushing (70)
is above the Weight Stop. Slide the Weight Stop
onto the Rear Upright.
Refer to drawing 2b. Secure the Weight Stop
(67) to the hole near the base of the Rear Upright
(56) with an M8 x 70mm Bolt (11) and an M8
Nylon Locknut (3). Slide the Weight Carriage (19)
onto the Rear Upright.
Press a 25mm Square Inner Cap (65) into the
Front Upright (42). Slide the Front Upright onto
the M8 x 63mm Carriage Bolts (1) in the Base
(4). Hand tighten an M8 Nylon Locknut (3) onto
each Carriage Bolt. Do not tighten the Nylon
Locknuts yet.
2
42
67
70
19
56
Hole
Hole
65
3
1
4
70
70
67
19
49
49
70 2a
2b
3
19
11
67
56
Indents