Viking M0706VR - Manual (Page 4)

7 6
Important Safety Instructions
• Do not heat unopened food containers; buildup of pressure may cause
the container to explode and result in injury.
• Always position oven racks in desired location while oven is cool. If rack
must be moved while oven is hot, do not let potholder contact hot
heating element in oven.
• Use care when opening oven door. Let hot air or steam escape before
removing or replacing food. Hot air or steam can cause burns to hands,
face and/or eyes.
• Keep oven vents unobstructed. The oven vent is located at the front of
the oven and vents into the room.
• Do not clean door gasket. It is essential for a good tight seal. Care should
be taken not to rub, damage, or move the gasket.
• No commercial oven cleaner or oven liner protective coating such as
aluminum foil should be used in or around any part of the oven. Improper
oven liners may result in a risk of electric shock or fire. Keep oven free
from grease buildup.
• Before self-cleaning the oven, remove broiler pan, broiler grid, oven racks,
and other utensils. Do not use your oven to clean other parts. A fan noise
should be heard during the cleaning cycle. If not, call service before self-
cleaning again.
• DO NOT TOUCH HEATING ELEMENTS OR INTERIOR SURFACES OF
OVEN. Heating elements may be hot even though they are dark in color.
Interior surfaces of an oven become hot enough to cause burns. During
and after use, do not touch or let clothing or other flammable materials
contact heating elements or interior surfaces of oven until they have had
sufficient time to cool. Other surfaces of the oven may become hot
enough to cause burns, such as the oven vent opening, the surface near
the vent opening, and the oven door window.
SAVE THESE INSTRUCTIONS
Getting Started
Getting Started
*NOTE: The PROBE function is included on Premiere Models.
Setting the Clock
Digital Display
The time-of-day must be
set before any other
program can be used.
When your oven is first
connected to the power
in your home, the timer
display will show --:--.
To program the time-of-day:
1. Press the “CLOCK/PROBE”* button once. 12:00 will be
displayed with the word SET in the upper right corner.
2. Turn the “SET” knob until the correct time-of-day is displayed.
AM and PM are not indicated.
3. Press the “CLOCK/PROBE” button again. The word SET will
disappear and the correct time is now set into the timer.
The time-of-day can be changed by following steps 1 through 3.
It cannot be changed while
there is a Bake Hours or Start
Time cycle programmed into
the timer.
Analog Display
(Designer Timepiece Models)
The time-of-day must be set
before any other program
can be used. When your
oven is first connected to the
power in your home, the
digital display will show
00:00. To program the
time-of-day:
1. Push and hold the “timer” and “bake hours” buttons at the
same time.
2. Turn the “Set” knob until correct time is displayed on the
digital clock.
3. Release “timer” and “bake hours” buttons.
The analog clock will automatically set after the digital time is set.
bake
hours timer start
time probe
temp Set
SET BAKE
HOURS
MIN/SEC
TIMER
START
TIME
CLOCK/
PROBE
SET