Viking M0706VR - Manual (Page 21)

40 41
Product Care
Product Care
Cleaning and Maintenance
To start the Self-Clean cycle:
1. Close the door completely.
2. Turn the oven selector knob clockwise to the self-clean mode.
3. Turn the temperature control knob past the clean setting until
the knob stops. At this time, the clean indicator light will come
on. Within 30 seconds the automatic door latch engages and
the oven indicator light comes on. The oven indicator light will
remain on until the oven reaches the self-clean temperature
and will then cycle on and off during the self-clean cycle.
When the oven reaches the elevated temperature needed for
self-clean, the door lock indicator light comes on.
4. The door lock indicator light will remain on until the self-clean is
completed or interrupted and the oven temperature drops to a
safe temperature. A complete cycle approximately 3 1/2 hours
with an additional 30 minutes needed for the oven to cool
down enough for the door latch to disengage. NOTE: A fan
noise will be heard during the self-clean cycle and will continue
to run for the 3 1/2 hour duration of the self-clean cycle.
5. When the cycle is completed, turn both the oven selector and
temperature control knob to the off position. When the oven
has completely cooled, open door and remove any ash from
the oven surfaces with a damp cloth.
Cleaning and Maintenance
Replacing Interior Halogen Oven Lights
Do not touch bulb with
bare hands. Clean off any
signs of oil from the bulb
and handle with a soft
cloth.
1. Unsnap glass light cover
at opposite end from
metal hinge.
2. Firmly grasp light bulb
and pull out.
3. Replace with a 12V-25W
halogen bulb.
4. Replace the light cover by
first sliding into metal
hinge and then snapping
closed on opposite end.
5. Reconnect power at the
main fuse or circuit
breaker.
Power Failure
Do not attempt to use during a power failure.
Unit will not function.
CAUTION
DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BEFORE REPLACING BULB.
To stop the Self-Clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the
temperature control knob and the oven function selector knob to
OFF. When the oven temperature drops to a safe temperature,
the automatic door latch will release and the oven door can be
opened. When the oven has completely cooled, remove any ash
from the oven surfaces with a damp sponge or cloth.
Before starting the Self-Clean cycle:
1. Remove the oven racks, and any other items/utensils from the
oven. The high heat generated during the cleaning cycle can
discolor, warp, and damage these items. The oven rack
supports are designed to remain in the oven during the Self-
Clean cycle. Do not use foil or liners in the oven. During the
Self-Clean cycle foil can burn or melt and damage the oven
surface.
2. Wipe off any large spills from the oven bottom and sides.
Never use oven cleaners inside a self-cleaning oven or on
raised portions of the door.
3. Some areas of the oven must be cleaned by hand before the
cycle begins. Soils in these areas will be baked on and very
difficult to clean if not removed first. Clean the door up to the
gasket, the door frame, and up to 2 inches inside the frame
with detergent and hot water. Rinse thoroughly and dry.