VIEWSONIC PJD6212 - Manual (Page 15)

EN-12
Replacing the Battery
For the first time use:
Remove the transparent insulation tape by pulling
it before use.
For battery change:
1.
Push the catch to the left and remove the battery
holder.
2. Remove the old Lithium coin cell and install new one
(CR2025). Ensure that the side with the mark “+” is up.
3. Push the battery holder back into the remote control
until you feel a click.
Caution
„
Risk of explosion if battery is replaced by an incorrect type.
„
Dispose of used batteries according to the instructions.
„
Make sure the plus and minus terminals are correctly aligned when loading a battery.
„
Keep the battery out of the reach of children.
„
Do not recharge the battery or expose the battery to fire or water.
„
Do not dispose the used battery along with household waste. Dispose u
batteries according to local regulations.
„
Danger of explosion may happen if batteries are incorrectly replaced.
Replace only with the same type recommended by the manufacturer.
„
Battery should not be in or near to fire or water, keep batteries in a dark
and dry place.
„
If suspect battery leakage, wipe out the leakage and then replace a new bat
the leakage adheres to your body or clothes, rinse well with water immediat