VIEWSONIC VS13645 - Manual (Page 27)

ViewSonic Pro8500 23
Operation
Powering On/Off the Projector
Powering On the Projector:
1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press to turn on the projector.
The projector takes a minute or so to warm up.
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
„ If you are connecting multiple sources to the projector simultaneously, press
SOURCE on the projector to select your desired signal or press your desired
signal key on the remote control.
Warning
„ Remove the lens cap first before powering on.
„ Never look into the lens when the lamp is on. This can damage your eyes.
„ This focal point concentrates high temperature. Do not place any object near
it to avoid possible fire hazard.
Powering Off the Projector:
1. Press to turn off the projector lamp. You will see a message "Power off"
appear on the screen.
2. Press again to confirm.
„ When the Power LED begins flashing, the projector has entered stand-by
mode.
3. Disconnect the AC power cord from the electrical outlet and the projector.
4. Do not turn on the projector right after power off