Visioneer One Touch 9420 - Manual (Page 23)

16 V ISIONEER O NE T OUCH 9420 USB S CANNER U SER ’ S G UIDE
If you are using Windows XP and have plugged the USB cable into
a USB 1.1 port, an information bubble may open explaining that
“A HI-SPEED USB device is plugged into a non-HI-SPEED USB
hub”. Plug the USB cable into a USB 2.0 port (if available) or just
disregard the message. If you leave it plugged into the USB 1.1
port, your scanner may scan a bit slower than with a USB 2.0 port.
Your computer recognizes that a scanner has been plugged into the
USB port. The computer loads the appropriate software to use the
scanner.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. For Windows
XP or Windows Vista, you will see a message similar to the following
that your new hardware is found and ready to use.