Vidikron Vision 110 - Manual (Page 28)

Installation
14 Vidikron Vision Model 110 Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the Vision 110 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2
If installing a Vision 110/CineWide or Vision
110/CineWide with AutoScope: Install fixed CineWide base
plate or AutoScope lens motor 22
3 Mount the projector 28
4 Connect signal sources to the projector 29
5 Connect external controller to RS-232 port (optional) 34
6
Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional) 35
7
Connect projector and lens motor (if present) to AC power
and power up 36
8
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 37
9
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 17, 38
10 Install CineWide anamorphic lens (optional) 39
11
CineWide lens adjustments: position, pitch (angle), geometry
and focus 41
12
Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position 47 through 54
Note