Viking AD128128M - Manual (Page 12)

AD6464M / AD128128M Rev. 5
Figure 6
On the top of the card tray, there is a hole above each module slot. When the tip of the
handle is just below this hole, start to push the handle downwards as in the figure. The tip of
the handle enters the hole and the card is locked and proper contact ensured when the
handle is in downright position.
Do not use excessive force; the card should enter easily – proper insertion is
almost effortless.
3.4.2 Card removal
To remove a module card from the sub-rack frame, release the card by moving the red
handle until it is in horizontal position, as shown in the figure below. Then pull the card out
of the sub-rack with the red handle.
Figure 7
3.4.3 Status LEDs and Reset button
There are 4 LEDs on the front side of the SysCon-SM card, and a reset button on the rear
side.
Status LEDs
Figure 8
network-electronics.com | 12