Vidikron Vision 30 - Manual (Page 29)

29 Vidikron Vision Model 30 Owner’s Operating Manual
Removing the Lens
Cap
Basic Operation
Focus
Zoom out Zoom in
• Adjust the projected image size with the
zoom ring on the lens. To focus the image,
rotate the focus ring on the lens.
Adjusting the Zoom
and Focus
• Press the lens latches together to remove
the lens cap.
• To replace the cap, push it squarely over
the lens until it snaps on.
• To adjust the projector height or projection
angle, or to compensate for a mounting
surface that isn’t level, turn the four
adjustable feet on the bottom of the
projector.
Adjusting Projector
Height or Projection
Angle
L-BOX
I-WIDE CINEMA C-FILL
MEM1 ISF
NT
ISF
DAY
DEF
ON OFF
COMP 1
COMP 2
S-VID VIDEO
RGB HD HDMI
ANA 4X3
Turning on the Power
• Turn on the main power switch on the rear
of the projector. The POWER LED will light
orange.
• Press the ON button on the remote control
to turn on the projector. The POWER LED
flashes orange during the warm up period,
then lights solid green.
• “Searching….” appears on the screen before
the projector identifies the input signal,
and remains there until a valid signal is
detected.
• If an incompatible input signal exceeds
the range of the projector, a “No signal
supported” message appears on the screen.
This message remains on the screen until
you change the input signal.