Vidikron Vision 30 - Manual (Page 14)

14 Vidikron Vision Model 30 Owner’s Operating Manual
Connector Panel
Controls and Functions
To access the connector panel, press the
door release button so it pops out. Turn
the knob clockwise or counter-clockwise
and pull firmly on it to open the door.
1. S-Video (mini DIN 4-pin) Y/C (S-video) signal input
2. 12v Trigger (mini jack, diameter 5.5 mm outside, 2.5 mm inside)
+12V output, active when the projector is turned on
3. Video (RCA Jack)
Composite video signal input
4. Component (RCA Jacks)
480i Component (Y/CB/CR) video signal input
5. HDMI (High-Definition Multimedia Interface) Input
Digital video signal input
6. RGB/ HDTV (BNC) or Progressive Scan DVD players
DTV Y/P
B
/P
R
or DTV RGB video signal input
7. RS-232C (RJ-11 Jack)
RS-232C control signal input (refer to page 51 for details)
To control the projector when signals from a remote control
cannot reach it, use the built-in keypad next to the connector
panel.
Because the built-in keypad has fewer keys than the remote
keypad, certain projector functions are accessible only through
the menu system rather than via a direct key. Built-In Control Panel MEMORY
MEMORY
AUTO
AUTO
POWER
POWER
MENU
/EXIT
MENU
/EXIT
SOURCE
/ENTER
SOURCE
/ENTER