Asus DSL-X11 - Manual (Page 56)

DSL-X11 User Manual
53
provides undelayed and continuous data transfer where data packets with higher
priority are given preference.
Click Quality of Service and the following page appears. Under Quality of
Service, there are two network share modes: Queue Config and QoS
Classification.
3.4.5.1 Enabling QoS
In this page, you can configure QoS queue management. By default, the system
enables QoS and sets a default DSCP mark to automatically mark incoming
traffic without reference to particular classifier.
Choose Advance Setup > Quality of Service and the following page appears:
Select Enable QoS to enable QoS and set the default DSCP mark.
Click Save/Apply to active QoS.
3.4.5.2 QoS - Queue Configuration
The queuing in packet QoS becomes effective only when packet is forwarded to
QoS-enabled PVC. Packet forwarding is determined by IP routing or bridging, not
under control of the packet QoS.
Click Queue Config and the following page appears. In this page, you can
configure QoS Queue. A maximum of 24 entries can be configured.