Asus DSL-X11 User Manual
Page 50
DSL-X11 User Manual
47
Source IP address: Enter an IP address. After you set the IP address,
outgoing packets (protocol selected packets) are blocked.
Source port: UPD/TCP source port or a range of ports.
Destination IP address: IP address of the destination (default: null).
Destination port: UPD/TCP destination port or a range of ports.
DSCP Mark: Marking DSCP that outgoing packets.
The following is an example of configuring the outgoing IP filtering.
The topology is as follows:
Request
I need to block PC1 whose IP address is 192.168.1.10. All outgoing
UDP/TCP packet from that PC1 (192.168.1.10) is not allowed.
Allow all outgoing traffic packet from PC2 (192.168.1.11).
Configuration
Step 1
By default, all outgoing IP traffic from LAN is allowed. Hence, all outgoing
IP packets from PC2 are allowed. The detailed configuration steps are as
follows: