Vivitek 51" Micro Display Projection TV - Manual (Page 15)

9
Connecting your Digital Video Equipment (HDMI & DVI )
Using Digital Video
Digital video equipment and other devices that have a digital interface compliant with the HDMI & DVI (Digital
Visual Interface) standard should be connected to the HDMI input of the RPTV.
Note:
1. Turn off the power of the RPTV and digital video equipment.
2. Connect a HDMI cable to the output terminal of your digital video equipment and the other end to the HDMI input
in the rear of your RPTV.
3. Turn on the power to the RPTV and your digital video equipment.
4. Select HDMI using the INPUT button on the right side of the RPTV or the remote control.
5. If your digital video equipment provides DVI output only, you should connect the DVI output from your Digital
video equipment to the HDMI input on the rear of your RPTV Connect both audio cables.
6. When using the DVI cable to reset OSD menu for "HDMI AUDIO" see page 27.
7. If your digital video equipment provides HDMI output, you should connect the cable from your digital video
equipment to the HDMI input on the rear of your RPTV
DIGITAL VIDEO Equipment
Back of Rear Projection TV
AUDIO
C
able
(Not
supplied)
HDMI
Cable
(Not
supplied)
DVI
TO
H
DMI
Cable
(Not
supplied)
DVI
HDMI
HDMI
Note:
a). The High Definition Multimedia Interface (HDMI). This interface is used between any audio/video source, such
as a set-top box, DVD player, or A/V receiver, and an audio or video monitor, such as a DTV. HDMI supports
standards, enhanced or high-definition video, plus-multi-channel digital audio on a single cable. The format
transmits all ATSC HDTV standards and supports eight-channel digital audio (up to 192kHz sampling rate),
with bandwidth to spare for future enhancements.
HDMI also uses a more compact and consumer electronics-friendly 15mm, 19-pin connector and will be fully
compatible with the former DVI-HDCP standard.
The HDMI input on your RPTV supports High-bandwidth Digital Content Protection (HDCP). HDMI encrypts the
transmission between the video source and the digital display for added security and protection.
b). Refer to your Digital Device's User Manual for more information about the video output requirements of the
product.
FOR SERVICE ONLY
(RS-232C)
Enter the S-VIDEO or the VIDEO terminal
can be used, but the S-VIDEO overrides
the VIDEO terminal.
Make sure ANALOG/DIGITAL RF
DIGITAL ANALOG
Inputs are connected correctly.
AUDIO(L/R) RGB L
L L
R
R R
AUDIO
S-VIDEO
VIDEO
AUDIO AUDIO AUDIO
AUDIO
(ATSC only) (ATSC only)
OUTPUT
DIGITAL
COAXIAL
OPTICAL
Y Y
P B P B
P R P R
L L
R R
AV IN1 AV IN1 AV IN2 AV IN2 COMPONENT IN1 COMPONENT IN2 ANTENNA IN
PC INPUT PC INPUT HDMI
CENTER CHANNEL CENTER CHANNEL
INPUT