VTech MI6895 - Manual (Page 40)

www.vtechphones.com 40
Answering system operation
Review announcement
Record announcement
Record memo
Review remote access
code
Change remote access
code
Turn system off
Turn system on
#7
*7
8
#9
*9
0
0
Listen to current outgoing announcement
Press after hearing the beep Record your new
announcement Press 5 to stop recording The system will
play back the announcement for confirmation.
Press after hearing the beep Speak after the system
announces “Record after the tone Press STOP when you
are done ” Start recording your memo Press 5 to stop
Listen to current remote access code
Change remote access code
When the system announces, “Answering machine off,”
press 0 again to turn the system back on
When the system is off, it answers after 0 rings and
announces, “Please enter your remote access code ” Enter
your remote access code
• Your phone may
not respond to
remote access
commands if
tones produced
by the telephone
are too short
Hold the buttons
down longer if
this occurs
• If accessing
from a touch
tone telephone,
press #5 to stop
recording
Purpose Press Action
Message alert
The message alert function produces an audio tone to remind you that there are new messages on
the answering system
Press
SETUP three times, the system announces “Message alert. To change the setting, press
CHANGE.”