VTech mi6885 - Manual (Page 38)

www.vtechphones.com 38
Answering system
Review announcement
Record announcement
Record memo
Review remote access
code
Change remote access
code
Turn system off
Turn system on
#7
*7
8
#9
*9
0
0
Listen to current outgoing announcement.
Press after hearing the beep. Record your new
announcement. Press 5 to stop recording. The system will
play back the announcement for confirmation.
Press after hearing the beep. Speak after the system
announces “Record after the tone. Press STOP when you
are done.” Start recording your memo. Press 5 to stop.
Listen to current remote access code.
Change remote access code.
When the system announces, “Answering machine off,”
press 0 again to turn the system back on.
When the system is off, it answers after 10 rings and
announces, “Please enter your remote access code.” Enter
your remote access code.
• Your phone may
not respond to
remote access
commands if
tones produced
by the telephone
are too short.
Hold the buttons
down longer if
this occurs.
• If accessing
from a touch
tone telephone,
press #5 to stop
recording.
Purpose Press Action
Message alert
The message alert function produces an audio tone to remind you that there are new messages on
the answering system.
1. Press
SETUP three times, the system announces “Message alert. To change the setting, press
CHANGE.”