VIEWSONIC PJD7383 - Manual (Page 57)

Operation 53
Using the PointBlank pen (PJD7383i/PJD7583wi
only)
The PointBlank pen can work in place of your regular computer mouse. Just hold the pen in
your hand, and point it at the projected image to point, click, and drag. It gives you more
flexibility to operate your computer without standing next to it.
Preparations
1. Connect the projector and your computer with a VGA cable, and a USB cable.
2. Turn on your computer and the PointBlank-compatible projector. Make sure the
projector is displaying the computer’s screen.
3. Enable the pen by selecting “Yes” in the SOURCE > PointBlank > Enabled menu.
The pen’s link light starts to blink.
4. Point the pen at the screen to point, click, and drag. Observe the pen’s light. It should
blink at a slower pace when it links to the projector.
Overview of the PointBlank pen
Using the PointBlank pen
Hold the pen the way you hold a remote control or a pen.
More settings are available on the SOURCE > PointBlank menu.
You can adjust the click speed of your pen with the Click Speed menu to make it response
faster or slower to meet your needs.
TYPE B
USB LAN
TYPE A
USB
RS 232 MONITOR OUT
COMPUTER IN1
COMPUTER IN2
S-VIDEO
VIDEO
AUDIO IN2 (R)
AUDIO IN2 (L)
AUDIO IN1
AUDIO OUT
MIC
Tip
Sensor
Right mouse button
Left mouse button
Middle button
Link light
Battery light
USB connector
Reset button