Uniden ANA9320 - Manual (Page 34)

PBX Features
L1 Key
Press the L1 key to initiate a call on Line 1.
L2 Key
Press the L2 key to initiate a call on Line 2.
conf Key
In PBX mode, the conf (conference) key must first be programmed.
Refer to the section entitled "Programming Conf in PBX".
xfer Key
Press xfer (transfer).
Dial the target number.
When the receiving party answers, press
xfer to complete the call.
Note: This feature is only available in PBX mode.
hold Key
Press once and the call is placed on hold.
Press
L1, L2 or TALK to resume the call.
pause Key
In PBX mode, the pause key is used to program the xfer and conf
feature buttons. Refer to the sections entitled "Programming xfer in
PBX" and "Programming Conf in PBX".
flash Key
Press once to cause a "Hook Flash" while on a call.
In standby mode, you can redial any one of the last three numbers
previously dialed.
ON/OFF MUTE Key
This key turns the handset MIC on or off while in TALK mode.
It toggles between on and off.
28
36
Y:...ANA9320 om.vp
Tue Dec 03 15:25:12 2002
Color profile: Disabled
Composite Default screen