Uniden ANA9320 - Manual (Page 30)

Programming Functions
PBX or PSTN
In the Programming mode, you can select either Analog PBX or PSTN
(Public Service Telephone Network) operation. The default is PSTN.
Available features of each mode of operation are illustrated in the
table below.
Feature Analog PBX PSTN
Conference Conference by PBX Connect Lines 1 & 2
Transfer Transfer by PBX Not Available
Note: Both Conference and Transfer commands must be programmed
to their respective keys before these features can be used.
* This note is for PBX mode.
Program Mode Setup
To enter the Program mode, perform the following steps:
1. In standby mode, press and
hold ” and #. While holding
them, press and hold TALK
until a short beep is heard and
the handset LCD displays:
2. Press RING/VOL, ON/OFF MUTE or 0 to switch between
PSTN and Analog PBX modes.
3. Press TALK to enter your
selection into memory.
The handset LCD displays:
The phone returns to standby mode.
For operation in PSTN mode, see page 29. For operation in PBX
mode, see page 28.
24
32
Y:...UC790B_2(ANA9320) OM.vp
Wed Dec 04 11:52:29 2002
Color profile: Disabled
Composite Default screen