Uniden DCT756 - Manual (Page 49)

49
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base unit. Your unit ships from
the.manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.
you.suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.
by.a.manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:
Reset.all.handsets.(see.page.5).
Re-register.each.handset.by.following.the.steps.on.page.4.
Traveling Out of Range
During.a.call,.as.you.begin.to.move.your.handset.too.far.from.your.base.unit,.noise.may.increase..If.you.pass.the.
range.limits.of.the.base.unit,.you.hear.a.beep.and.see.OUT.OF.RANGE.on.the.display,.and.then.the.handset.returns.
to.standby..You.may.return.to.the.call.if.you.move.your.handset.within.the.range.limits.of.the.base.and.press.
[ /flash] or.[ ].within.30.seconds.
Common Issues
If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve
your.problem,.please.call.our.Customer.Hotline.(see.back.cover.for.contact.information).
Symptom Suggestion
The.charge.LED.fails.to.light.
when.the.handset.is.placed.in.
the.cradle.
Make.sure.the.AC.adapter.is.plugged.into.the.base.or.the.charger.(if.you.
have.more.than.one.handset).and.wall.outlet.
Make.sure.the.handset.is.properly.seated.in.the.cradle.
Make.sure.the.charging.contacts.on.the.handset.are.clean.
•
•
•
The.audio.sounds.weak. Move.the.handset.and/or.base.away.from.metal.objects.or.appliances.and.
try.again.
Make.sure.you.are.not.too.far.from.the.base.
•
•
1.
.