Uniden DCT756 - Manual (Page 25)

5
Resetting Handsets
If.you.want.to.register.a.handset.to.a.different.base.or.replace.a.handset.with.an-
other one, you must first clear the registration information from the base and the
handset..
Press.and.hold. [ ] and.[#/>] on.the.handset.for.at.least.5.seconds.until.the.
SYSTEM.RESET.menu.appears..Select.the.DEREGISTER.HS.submenu..
WHICH.HANDSET?.appears.
Move.the.cursor.to.select.the.handset.ID.to.be.de-registered.from.the.list,.and.then.press. ..
DEREGISTER.HS.appears..
The phone asks you to confirm the deregistration. Move the cursor to select YES, then press ..A.
confirmation tone sounds. The handset clears the registration information from the base and then deletes its
own.link.to.the.base..The.handset.now.displays.MODELS.VARY!.CHARGE.HANDSET.ON.THE.BASE.FOR.
REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL..To.register.the.handset.to.a.base.see.page.4.
Setting up the Phonebook
Your.phone.lets.you.store.up.to.100.names.and.numbers.in.your.phonebook.in.
the.handset..Your.phone.shares.memory.between.your.phonebook.and.CID.en-
tries..Once.you.store.100.phonebook.entries,.CID.information.is.not.stored.and.
only.appears.during.a.new.incoming.call..When.phonebook.and.CID.entries.are.
full,.a.beep.sounds.and.MEMORY.FULL appears..You.cannot.store.any.additional.
names.and.numbers.unless.you.delete.some.of.the.existing.ones.
You.can.also.use.the.phonebook.to.store.a.group.of.numbers.(up.to.0.digits).
that.you.may.need.to.enter.once.your.call.connects..This.is.referred.to.
as. chain dialing.(See.page.34.for.instructions).
Creating Phonebook Entries
To.store.names.and.numbers.in.your.phonebook,.follow.these.steps:
When.the.phone.is.in.standby.mode,.press. [ ].
To.create.a.new.phonebook.entry,.move.the.cursor.to.select.STORE.NEW.
Press. . STORE/EDIT.NAME.appears.
Enter.the.name.for.this.entry.(STORE/EDIT.NAME) . Use.the.
1.
.
3.
1.
.
3.
4.