Uniden DECT1480 - Manual (Page 3)

Do not place the handset in any charging cradle without the battery
installed and the battery cover securely in place.
SAVE THESE INSTRUCTIONS!
CAUTION! Risk of explosion if battery is replaced by an incorrect type!
Dispose of used batteries according to the instructions. Do not open
or mutilate the battery. Disconnect the battery before shipping this
product.
For more details, see the Important Information section.
GETTING STARTED
Installing Your Phone
Charge the Battery
Unpack all handsets, battery packs,
and battery covers. If you need to
remove a battery cover, press in on
the notch and slide the cover down
and off.
Line up the battery connector with the jack inside the handset.
(The battery connector will only fit one way.)
Push the connector in until it clicks into place; tug gently on the
wires to make sure the battery pack is securely connected.
Replace the battery cover and slide it into place.
Connect the AC adapters to the
AC IN 8V
jacks on the base and on
each charger. Set the plugs into the notches.
Plug the other end of the adapters into standard 120V AC outlets.
Place one handset in the base and the other(s) in the charger(s)
with the displays facing forward. The display on each handset
should light up; if it doesn’t, reseat the handset or try plugging the
AC adapter into a different outlet.

1.
2.
.
4.
.
.
7.