Uniden DECT1480 - Manual (Page 23)

2
Plug the DSL filter into the telephone wall jack and plug your phone’s
base into the filter. Make a test call to make sure the noise is gone.
Liquid Damage
Moisture and liquid can damage your cordless phone.
If the exterior housing of the handset or base is exposed to moisture
or liquid, wipe off the liquid, and use as normal.
If moisture or liquid is inside the plastic housing (i.e. liquid can
be heard in the phone or liquid has entered the handset battery
compartment or vent openings on the base), follow these steps:
Handset Base
Remove the battery cover and disconnect
the battery.
Let dry for at least 3 days with the battery
disconnected and the cover off.
After the handset dries, reconnect the
battery and replace the cover. Recharge the
battery fully (15-20 hours) before using.
1.
2.
3.
Disconnect the AC
adapter to cut off
the power.
Disconnect the
telephone cord.
Let dry for at least
3 days before
reconnecting.
1.
2.
3.
CAUTION! DO NOT use a microwave oven to speed up the
drying process. This will cause permanent damage to the
handset, base and the microwave oven.
AC Adapter and Battery Information
Use only the supplied AC adapters. Be sure to use the proper adapter for the
base & any chargers.
Do not place the power cord where it creates a trip hazard or where it could
become chafed and create a
fire or electrical hazard.
Do not place the unit in direct
sunlight or subject it to high
temperatures.
Fully charged, the battery
should provide about 10
hours of talk time and about 7


•
•
•
•
AC
adapter
Base/Charger
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 8V AC @ 300mA
Battery
pack
Part number BT-1007
Capacity 500mAh, 2.4V DC
AC
adapter
Base/Charger
Part number PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 8V AC @ 300mA
Battery
pack
Part number BT-1007
Capacity 500mAh, 2.4V DC