Uniden DECT1480 - Manual (Page 27)

as these might not comply with FCC RF
exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal Industry Canada Terminal
Equipment Technical Specifications.
This is confirmed by the registration
number. The abbreviation IC before
the registration number signifies that
registration was performed based on
a Declaration of Conformity indicat-
ing that Industry Canada technical
specifications were met. It does not
imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence Num-
ber (REN) for this terminal equipment
is marked on the equipment itself.
The REN assigned to each terminal
equipment provides an indication
of the maximum number of termi-
nals allowed to be connected to a
telephone interface. The termination
on an interface may consist of any
combination of devices subject only to
the requirement that the sum of the
Ringer Equivalence Numbers of all the
devices does not exceed 5.
Radio equipment
The term IC before the radio certifica-
tion number only signifies that Indus-
try Canada technical specifications
were met. Operation is subject to
the following two conditions: (1) this
device may not cause interference,
and (2) this device must accept any
interference, including interference
that may cause undesired operation
of the device. "Privacy of communica-
tions may not be ensured when using
this telephone".
1-Year Limited Warranty
Evidence of original purchase is
required for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden
warrants, for one year, to the original
retail owner, this Uniden Product to
be free from defects in materials and
craftsmanship with only the limitations
or exclusions set out below.
WARRANTY DURATION: This warranty
to the original user shall terminate
and be of no further effect 12 months
after the date of original retail sale.
The warranty is invalid if the Product
is (A) damaged or not maintained as
reasonable or necessary, (B) modi-
fied, altered, or used as part of any
conversion kits, subassemblies, or any
configurations not sold by Uniden, (C)
improperly installed, (D) serviced or
repaired by someone other than an
authorized Uniden service center for a
defect or malfunction covered by this
warranty, (E) used in any conjunction
with equipment or parts or as part of
any system not manufactured by Un-
iden, or (F) installed or programmed
by anyone other than as detailed by
the owner's manual for this product.
STATEMENT OF REMEDY: In the event
that the product does not conform to
this warranty at any time while this
warranty is in effect, warrantor will