Uniden DECT1480 - Manual (Page 10)

10
To switch to all capital letters, press
*
. The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first letter
and wait a few seconds (or press RighT ); the cursor will move to the
next space. Enter the next letter.
Press # to enter a blank space.
To change a letter, move the cursor to that letter and press ClEaR to
erase the letter. Then, enter the new one.
To erase the entire entry, press and hold ClEaR .
Press 0 to cycle through all available symbols and punctuation.
USING YOUR PHONE
Basics
To... Earpiece Speakerphone
make a call: Dial the
number, then
Press Talk/Flash . Press spEakER .
answer a call Press Talk/Flash . Press spEakER .
hang up Press End or put the handset in the cradle.
switch between the
speaker & earpiece
Press spEakER .
mute the microphone
during a call Press mEssagEs/mUTE . Press again to turn
the microphone back on.
put a call on hold
Press ClEaR/inTERCom . After 5 minutes on
hold, the call will be disconnected.
return to a call on hold Press Talk/Flash . Press spEakER .
mute the ringer for this
call only While the phone is ringing, press mEssagEs/
mUTE .
Changing the Volume
You can set speaker volume levels separately for the base and each
handset. You can also set the earpiece volume on each handset.
Anytime you are listening to a speaker or earpiece, press Up to
increase the volume and down to decrease it.





