Universal Remote Control (URS) RF30 - Manual (Page 21)

39 40
Er
asing Lear
ned Buttons
, Macr
os or
Favor
ite Channels
ERASING COMMANDS
Re-setting RF30 to Or
iginal
Factor
y Default Settings
ERASING COMMANDS
STEP 4:
If you press ALL, the RF30
displays a “SURE?” button.
After the SURE button is pressed,
all the buttons will be erased.
If you press DEVICE, a list of
Components will appear. Press
the Component button that you
wish to erase. The bottom of the
screen will flash ERASE twice,
then ERASED.
If you press KEY, you’ll have to
navigate to the Component and
Page you want using the MAIN,
COMPONENT and PAGE buttons.
Press a button to erase it. The
bottom of the display will flash
ERASE twice, then ERASED.
STEP 5:
To return to normal operating
mode, press the MAIN button
four times
STEP 1:
press and hold both the MAIN
and the STOP buttons for 10
seconds.
STEP 2:
After 10 seconds, the RESET
screen appears. Press the ALL
button. The RF30 will display a
“SURE?” button. Press the
SURE button to erase all of your
settings and return to the factory
default setup.
MAIN
BUTTON
STOP
BUTTON
SURE
BUTTON
SURE
BUTTON
Re-setting RF30 to Original
Factory Default Settings
If you want to start with a clean slate, you can re-set the
RF30 its original factory default settings by performing the
following steps.
NOTE: This process will essentially erase EVERYTHING you
have programmed into the RF30.