Customizing – Universal Remote Control (URS) RF30 User Manual

Page 19

Recalling Pr

e-Pr

ogr

ammed

Setup Code Number

CUSTOMIZING

Cloning Other RF30s

CUSTOMIZING

Recalling Pre-Programmed Setup Code
Numbers

In case you didn’t write down the Pre-Programmed Code
Numbers that you used to set up your RF30, you can easily
recall them using this simple process:.

Cloning Other RF30s

If you are fortunate enough to own more than one RF30,
you’ll be happy to know that you can easily copy and
transfer all the setup from one RF30 to another. Just follow
these easy steps:

STEP 1:

Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3 seconds,
until the word “SETUP” is
displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.

STEP 2:

Press the RECAL button on the
LCD screen. Each of the four
screen pages will display the
Component name and its
corresponding code number.

STEP 3:

Write down the code numbers
as they appear for future
reference. Page 43 of this
manual provides a convenient
space for you to record your
code numbers.

STEP 4:

Return to normal operation by
pressing the MAIN button twice.

IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.

STEP 1:

For both the programmed RF30
that you want to clone, and
unprogrammed RF30, press and
hold the MAIN and ENT (Enter)
buttons at the same time for
approximately 3 seconds, until
the word “SETUP” is displayed
at the top of their respective LCD
touch screens. This signals that
both remotes are now in setup
mode.

STEP 2:

Press a PAGE button on each
remote to bring up Page 2 of
Setup and display the CLONE
button.

STEP 3:

Press the CLONE button on each
remote.

NOTE: Use the (

or ) page buttons to

display any of the four pages of
Components and their code numbers.