Universal Remote Control (URS) RF30 - Manual (Page 13)

23 24
Favor
ite Channel Setup
CUSTOMIZING
Favor
ite Channel Setup
CUSTOMIZING
This is one of RF30’s most desirable features. Once it’s set up,
you can select up to 40 favorite channels with the press of a
button - without the need to remember or type in a channel
number. Let the channel surfing begin!
To access Favorite Channel listings, press the MAIN button
to bring up Page 1 of the MAIN menu. Then press the FAV
(Favorite Channel) button on the LCD touch screen. The
screen changes to a list of favorite TV channels. Each button
can be set to instantly select the channel on your TV. There
are five pages of eight favorite channel buttons for a total of
40. Simply touch the PAGE buttons to display the other pages
of favorite channels.
To setup a Favorite Channel button, follow these steps:
Favorite Channel Setup
PAUSE
BUTTON
DEVICE
BUTTONS
STEP 1:
Press and hold the MAIN and
ENT (Enter) buttons at the same
time for approximately 3
seconds, until the word “SETUP”
is displayed at the top of the LCD
touch screen. This signals that
you are now in setup mode.
STEP 2:
Press the FAV display button.
The top of the display will show
“FAV”. The bottom of the display
will flash “SELECT”
STEP 3:
Use the Page buttons until you
locate the name (i.e., ABC, CBS,
NBC) of the favorite channel you
want to setup.
STEP 4:
Press the favorite channel
button you want to setup. The
top of the screen will change to
show the channel name. The
bottom of the screen displays
“STEP0”, indicating that you
have not entered the channel
number yet.
STEP 5:
Press either the TV, SAT or
CABLE Component button (select
the Component you use to enter
channel numbers).
STEP 6:
Press each of the number
buttons for the channel.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in
SETUP mode. If you don’t press a button
within 30 seconds, SETUP will disappear
from the screen, signaling that you have
exited setup mode and you will need to
start over.
Note: If a number is repeated when set-
ting the channel (for example, channel
“33” or “522’), it is usually best to set a
half second delay in between the identi-
cal numbers by pressing the (II) PAUSE
button. Each press of the PAUSE button
increases the delay by a half second.
NOTE: Some brands of television require
an ENT (Enter) command after the chan-
nel numbers.
FAV
BUTTON