Uniden DSS3455+1 - Manual (Page 55)

Screening Calls
If you activate the call screening feature, you can listen to callers leaving a message without answering the phone
(see on page 50). You can always hear callers from the base speaker. To screen an
incoming call from the handset:
Activating Call Screening
• Press when the system is answering. If another handset is screening a call, you will hear a beep
and you will not be able to screen the call.
• To answer the call, press .
• To stop screening the call, press .
You can record a conversation between two seconds and ten minutes long from the handset or the base. These
recorded conversations are treated just like regular messages. When the answering system is full, FL will appear
on the base LCD and recording will be terminated. You can not record three-way calls or intercom conversations.
[select/ ]
[ / flash]
[ ]
Recording a Conversation
Note: Every state has different regulations governing the recording of conversations over the telephone. Make sure to check your local,
state and federal laws before using this product to record any telephone conversation in order to determine that your use is in
compliance with such laws or guidelines.
From the base
[memo/call rec]
[memo/call rec] [ ]
From the handset
1. During a conversation, press and
hold .
2. The message counter LED flashes
"- -". A confirmation tone that can be
heard by both parties sounds during
recording.
1. Press , or .
2. You will hear a confirmation tone, and
the message counter LED stops
flashing.
1. During a conversation, press .
2. Move the cursor to select CALL RECORD, and
then press .
3. RECORDING A CALL and R appear on the
display. A confirmation tone that can be heard by
both parties sounds during recording.
1. Press .
2. Move the cursor to select CALL RECORD, and
then press .
3. STOP RECORDING appears on the display,
and you hear a confirmation tone.
[menu/clear]
[select/ ]
[menu/clear]
[select/ ]
Starting a
recording
Stopping a
recording
[54]