Uniden DSS3455+1 User Manual
Page 17
[16]
2. Check to make sure the battery is fully charged. (If you don't see the "battery full" icon, check to make sure
the battery is properly connected).
3. Change the dial mode (instructions below).
Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These
days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If
your phone company uses pulse dialing, you will need to change your phone’s dial mode. If you don't get a dial
tone or can't connect to the telephone network, please follow the steps below to modify your phone’s settings:
1. Press
. Select the GLOBAL SETUP menu, and then the
DIAL MODE submenu.
2. Scroll
to select PULSE.
3. Press
. You will hear a confirmation tone.
If you ever need to change the dial mode back to tone dialing, follow the
same procedure, but select TONE in step 2.
Line up the holes on each side of the handset. To attach the belt
clip, insert into the holes on each side of the handset. Press down
until it clicks.
, pull either side of the belt clip to release
the tabs from the holes.
Changing the Dial Mode (Australian Model Only)
Installing the Belt Clip
[menu/clear]
[
]
[select/
]
To remove the belt clip