Resetting the handset without the base, Changing the digital security code – Uniden DCT738 User Manual

Page 59

When.the.base.information.is.deleted,.the.handset.displays.MODELS.VARY!.CHARGE.HANDSET.ON.THE.
BASE.FOR.REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL.

Re-register.the.handset.to.the.base.(see.Registering Accessory Handsets.on.page.9)..

If.the.handset.cannot.contact.the.base,.it.will.display.UNAVAILABLE..Make.sure.the.handset.is.in.range.of.the.base.
and.the.base.is.connected.to.power.

Resetting the Handset Without the Base

If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.lost.or.somehow.incapacitated),.you.can.still.
reset.the.handset.and.use.it.with.another.base.

Press.and.hold.[ ].and.[

].for.at.least.5.seconds.

Move.the.cursor.to.select.REPLACING.BASE.and.then.press.[select/

]..REPLACE.BASE.appears.

Move.the.cursor.to.select.YES,.and.then.press.[select/

]

. You hear a confirmation tone, and the handset

deletes.its.own.base.information.without.contacting.the.base..The.handset.displays.MODELS.VARY!.
CHARGE.HANDSET.ON.THE.BASE.FOR.REGISTRATION.OR.REFER.TO.OWNER’S.MANUAL...

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the
manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.you.
suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.by.a.
manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:

Reset.the.handset.(see.Resetting the Handset on.page.57).

Re-register.each.handset.(see.Registering Accessory Handsets.on.page.9).