Uniden DCT738 - Manual (Page 55)

54
To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:
Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.
after.about.0.rings.and.sounds.a.series.of.beeps.
During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.[0].and.enter.your.security.code/PIN.
within.two.seconds.(see.
Setting a Security Code or Personal Identification Number (PIN).on.page.49).
The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..You.hear.
“To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero”.followed.by.a.beep.
Enter a remote command from the chart below. You have 15 seconds to enter the first command; after the
first command, you have two seconds to enter each command.
Command Function Command Function
[0].and.[1] Repeat.a.message* [0].and.[6] Answering.system.on
[0].and.[2] Play.incoming.messages [0].and.[7] Memo.record.start/stop
[0].and.[3] Skip.a.message [0].and.[8] Greeting.message.record.start/stop.
[0].and [4] Delete.a.message [0].and.[9] Answering.system.off
[0].and [5] Stop.operation [1].and.[0] Help
*. If.you.press.[0].then.[1]
in the first four seconds of a message, the system skips to the previous message..
If.you.press.[0].then.[1]
after the first four seconds of a message, the system repeats the current
message.
When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter.another.command.from.the.chart.within.two.seconds.
Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.
.
2.
3.
4.
5.
6.