Uniden D3580 - Manual (Page 22)

22 - English
To... From the base From a handset
delete a
message
While a message is playing, press
delete .
While a message is
playing, select 4 (number
key).
delete all
messages
With the phone in standby, press
delete ; press delete again to confirm. Not available.
play old
messages
After the system plays all new messages,
press play/stop again. select 2 (number key).
stop playback Press play/stop . Select 5 (number key).
Screening Your Calls
You can use the answering system for call screening. While the system takes a
message, you can listen on the base speaker (if you turn on Call Screen) or from a
handset. Only one handset can screen calls at a time. If another handset tries to
screen calls, it beeps and returns to standby.
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller over
the speaker.
Press message/mute .
answer the call NA Press Home/FlasH .
mute the call screen
without answering*
Press play/stop .
Press end or return the
handset to the cradle.
* If you mute the call screen, the system continues taking the message: it just stops
playing through the speaker.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone. Before you
can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select Answering Setup , then select
Security Code . Use the number keypad to enter a two-digit security code ( 01 to 99 ).
Press menu/select when you’re finished.
#
Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number & wait until the system answers. (If the system is turned
off, it answers after 10 rings & sounds a series of beeps.)
2. During the greeting or beeps, press 0 and immediately enter your security code.
If you enter it incorrectly 3 times, the system hangs up and returns to standby.