Remote interface – Uniden SC200 User Manual
Page 40

Remote Interface
You can program your
SC200 with two peripheral devices
using the Remote Interface Cable port.
Through the Clone Mode you can program all the
frequencies of your scanner with SC200 scanner or through
a PC using third-party scanner programming software.
Connecting the Scanner
Scanner to PC
Plug the smaller end of the supplied remote interface cable
into the remote port on the right side of your scanner.
When connecting the cable to your scanner, make sure the
label side of the cable is facing forward.
Plug the other end of the cable (DB-9 serial connector) into
a personal computer’s serial port. A few PC’s may require
an adapter, most will not. You may need a DB-9 to DB-25
null modem adapter, available at most computer stores. Of
course, make sure your PC is turned on.
Scanner to Scanner
Plug the scanner end of the supplied remote interface
cables into the remote ports on the right sides of each
of the two scanners. When connecting the cable to
your scanner, make sure the label side of the cable is
facing forward.
38
40
C:...UC303ZL(SC200).VP
Mon Mar 18 17:35:24 2002
Color profile: Disabled
Composite Default screen