Uniden WDECT 2345+1 - Manual (Page 15)

E. Mount the Base Unit on a Wall
Standard wall plate mounting
DC IN 9V
TEL LINE
This phone can be mounted on any standard wall plate.
1) Detach the wall mount adaptor from the bottom
of the base.
2) Snap the wall mount adaptor into the notches on
the base bottom as shown.
3) Plug the AC adaptor into the jack.
Wrap the AC adaptor cord inside the molded
wiring channel as shown.
4) Plug the AC adaptor into a standard 240V AC
wall outlet.
5) Plug the telephone line cord into the
jack.
6) Plug the telephone line cord into the telephone
outlets.
7) Raise the antenna to a vertical position.
8) Align the mounting slots on the base with the
mounting posts on the wall. Then push in and
down until the phone is firmly seated.
9) Press and push up on the handset holder to lift
and remove it. Turn it over and rotate it 180°,
then slide it down into its slot and snap it back
into place so it holds the handset.
10) Connect the handset cord to the left side of the
phone and corded handset.
GETTING
ST
ARTED
[14]