Uniden WDECT 2345+1 - Manual (Page 12)

!
!
Use only the
Do not place the
power cord
where it creates
a trip hazard or
where it could
become chafed
and create a fire
or electrical
hazard.
supplied [AAD-
041S] AC
Adaptor. Do not
use any other AC
adaptor.
[11]
B. Connect the base unit
1) Connect the handset cord to the left side of the
phone and the corded base handset.
2)
3) Connect AC adaptor to the jack and
to a standard 240V AC wall outlet.
4) Set the base on a desk or tabletop.
Place the corded base handset on
the base.
5) Raise the antenna to a vertical
position.
If your telephone
outlet isn't modular,
contact your
telephone company
for assistance.
Connect the telephone line cord to the Jack TEL LINE
Test Telephone Line Without Power
DC IN 9V
Pick up the base handset and listen for a dial tone.
If a dial tone is achieved after 2 seconds then base
handset can be used during a power failure.
If there is no dial tone your telephone may be on a long line
length in which case no dialling functions will be available
during power failure.