Uniden UH013 - Manual (Page 7)

UNIDEN Model UH013 UHF CB Radio
Mounting Options
Mounting the complete radio (Transceiver with Display Unit)
Remote mounting of the Transceiver Unit
6
The radio can be mounted complete - or - with the Display Unit remote of the Transceiver.
a) Plug in display cable from the
Display Unit to the transceiver.
b) Hinge the Display Unit into the
transceiver as shown in the
diagram, then snap closed.
c) Should you wish, at a later stage,
to position the Display Unit remote
from the Transceiver, release the
Display Unit by pushing up the slide
on the side.
If the Display Unit is not already separate
of the Transceiver then remove it as
detailed in c) above.
Fix the Transceiver Mounting Bracket in
an appropriate location (screws and
washers supplied). Then fix the
Transceiver in the bracket using the Knob
bolts supplied d).
The bracket can be fixed on the top or
under the transceiver. An arced slot e)
allows you to mount the transceiver at an
angle.
b
b
c
d
e
a