Uniden UH013 - Manual (Page 3)

Preventive Maintenance: The following system checks should be made every six to twelve months:
Check the Standing Wave Ratio (SWR).
Inspect the tightness of all electrical connections.
Inspect the antenna coaxial cable for wear or breaks on the shielding.
Inspect the tightness of all screws and other mounting hardware.
The Uniden UH013 is designed to provide you with years of trouble free service. Its rugged components and
materials are capable of withstanding harsh environments.
We are certain that you will enjoy your UH013. Please read this Operating Manual carefully to ensure you gain
the optimum performance of the unit.
Features
Detachable Display Unit
Transmit & Receive FM 40CH (UHF-CB, TX Power 5w)
2 Levels Preset Squelch
Wide Band Scanner (400MHz - 512MHz) = WS Function
Band Search Function (4 Bands separately)
LCD Display with Backlight
Signal Strength Meter
RF Power Indicator
One touch Instant Channel recalling
Duplex Capability (from CH01 - CH08 per channel)
Group Scan and Priority Channel Watch
Open Scan
Busy Channel Lock-out
38 Built-in CTCSS codes
Volume Control with Power On/Off Switch
VOX (Voice Activated Function) optional VOX headset
required
9 Step VOX Mic sensitivity adjustment
Memory backup if power fails
Optional Tone Squelch Unit Function
Tone Squelch Function (5/6 Tone) optional
Tone Calling Function (5/6 Tone) optional
Tone Squelch Scan optional
2
Introduction
NOTE
Blackening may occur on the Liquid Crystal Display if the UH013 has been subjected to extreme high
temperature (above . This is not a fault. Normal LCD operation resumes when the temperature
stabilizes back to standard operating conditions (0 to 55°C).
60°C)
Troubleshooting: Should the unit malfunction or perform poorly, follow these procedures:
If the transceiver is completely inoperative: Check the power cord and fuse.
If there is trouble with receiving: Check the VOLUME control setting. Be sure the SQUELCH is adjusted
properly. Possibly the radio is over-squelched.
If there is trouble with transmitting: Check that the transmission line (coaxial cable) is securely connected
to the ANTENNA connector. Check that the antenna is fully extended for proper operation. Check that all
transmission line (coaxial cable) connections are secure and free of corrosion.
UNIDEN Model UH013 UHF CB Radio