Uniden UH013 - Manual (Page 11)

UNIDEN Model UH013 UHF CB Radio
Operation
Press and hold for 2 seconds to switch
Duplex ON. The DUP icon appears.
If Duplex is not required - press and hold for
2 seconds again to switch Duplex off.
Only channels 01 - 08 are available for Duplex
10
NOTE
Check with your local Retailer for
information on available Repeaters.
Scanning
The UH013 has a scanning feature that allows you to search for active channels automatically.
Furthermore, the UH013 is designed to have two types of scanning; Open Scanning (OS) and Group Scanning
(GS), to give you flexibility and allow you to use the radio more effectively.
Press and Scanning starts. The SCN
icon appears.
Press again to stop scanning.
SCAN
Open Scan (OS) Mode
Allows continuous scanning of channels stored in the Open Scan memory. If an active channel is found, scanning
will stop on that channel.
This example shows CH40 active.
If the received signal ceases, the unit will wait 3 seconds for the signal
to return, otherwise scanning resumes.
To skip the active channel, press momentarily. Scanning resumes. To deactivate SCAN, press
or the PTT button on the microphone. MEM
VOX
CTCSS
NOTE
If SCAN is deactivated while on an
active channel, the UH013 will stay on
that active channel. If no channels are
active, the UH013 will reinstate the
starting channel.
NOTE
OS Mode is indicated by the absence of
the GS icon.
VOL
INST SQT
CTCSS SET/SKIP
SCAN MEM SRCH
DUP OS/GS TSQ
S/RF
S/RF
INST SQT
CTCSS SET/SKIP
SCAN MEM SRCH
DUP OS/GS TSQ
S/RF
MHz
MHz
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
Operating the UH013 in Duplex Mode
For this example we are adopting CH01 as the channel being used in your area for repeater use.
DUP
DUP
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
MHz
SCAN
SCAN