Uniden UH013 - Manual (Page 12)

To deactivate SCAN, press the button
or the PTT button.
Press and hold for 2 seconds to turn
off Group Scan Mode.
UNIDEN Model UH013 UHF CB Radio
Operation
11
If the Priority Channel becomes active the radio will stay on that channel for as long as the signal is present. If
the received signal ceases, Priority Scanning continues after 3 seconds.
If scanning stops on a channel which is not a Priority Channel, UH013 will continue monitoring the Priority Channel
for activity while listening to the active one.
Group Scan (GS) Mode
Allows you to monitor a Priority (Instant) Channel while scanning (Instant Priority channel see p.12)
To use GS Mode Scanning, press and hold for 2 seconds.
GS icon appears on the display.
GS Scanning checks the Instant Priority Channel for activity regularly.
VOX
CTCSS
Programming Scan Channels
Select which Scanning Mode you wish to use
- OS or GS.
Select the channel you want to store.
Press to store. M icon appears and
a short tone beep is heard.
To remove the channel from Memory, press
once more. The M icon disappears.
MEM
MEM
S/RF
Rotary
Channel
Selector
SCAN
NOTE
OS is indicated by the absence of
the GS icon.
SCAN
NOTE
If SCAN is deactivated while it is tuned to an active channel, the UH013 will stay on that active
channel. If none of the channels are active, the UH013 will reinstate the Starting Channel.
If SCAN is deactivated while it is turned to the Instant Priority Channel, the UH013 will remain on
the Instant Priority Channel.
If GS Scanning is initiated when there are no channels programmed in GS memory, an error tone
will be heard and scanning will not start (see Programming Scan Channels - below). NOTE
S/RF
SLCT
STORE
INST SQT
CTCSS SET/SKIP
SCAN MEM SRCH
DUP OS/GS TSQ
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
MHz
MHz
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
SLCT
STORE
Rotary
Channel
Selector
INST SQT
CTCSS SET/SKIP
SCAN MEM SRCH
DUP OS/GS TSQ
S/RF
MHz
SLT SRC HLD SQT M
CAL TSQ DUP
MON SCN GS BCL INS
SCAN