Uniden XCA750 - Manual (Page 22)

4. Press the memory location
number (0-9).
Chain Dialing
On certain occasions, after dialing a number, you may be requested by the
party or service you are calling to enter a special access code, such as when
performing a banking transaction. To do this, simply:
1. Store the access code into one of the memory numbers.
2. Dial the main number.
3. At the appropriate time, press followed by the memory location
number where the access code is saved.
Erasing a Stored Number
To erase a number previously stored in a memory location (0-9), follow these
steps:
1. Remove the Handset from the
Base Unit.
2. Press twice.
3. Press the memory location
number (0-9).
A tone indicates the number
is erased.
Note: An error tone will sound and the erase procedure will be canceled if
more than 20 seconds elapse between each keystroke entry or
step.
37 38