Uniden DSS7955+1 - Manual (Page 71)

70
Symptom Suggestion
Can’t make or receive calls. Make sure that you are not too far from the base.
Make sure the line is not in use. If an outside call is already using a line, you
cannot use that line to make another outside call.
Check both ends of the base telephone line cord.
Make sure the AC adaptor is plugged into the base and wall outlet.
Disconnect the AC adaptor and reconnect.
Change the Digital Security Code (see page 69).
•
•
•
•
•
•
The handset doesn’t ring or
receive a page.
Make sure that you are not too far from the base.
Charge the battery in the handset for at least 5-20 hours by placing the handset
on the base or charging cradle.
Change the Digital Security Code (see page 69).
•
•
•
Severe noise interference. Keep the handset away from microwave ovens, computers, remote control toys,
wireless microphones, alarm systems, intercoms, room monitors, fluorescent
lights, and electrical appliances.
Move to another location or turn off the source of interference.
•
•
The Caller ID does not
display.
The call was placed through a switchboard.
Call your telephone provider to verify your Caller ID service is current. There
may be a problem with your Caller ID service.
•
•
You cannot register the
handset at the base.
Charge the battery pack in the handset for 5-20 hours.
Change the Digital Security Code (see page 69).
Make sure you have not stored 0 handsets already.
•
•
•
The handset doesn’t
communicate with other
handsets.
Change the Digital Security Code (see page 69).
Make sure that you have registered all handsets.
•
•